Transaxle Oil Cooler Line Seals: Installation
CAUTION:
Failure to lubricate oil cooler line seals with DEXRON-III ATF before installing oil cooler line assembly into seals may cause damage to seals.
- Place a new transaxle cooler line seal in case bore. Install Cooler Line Seal Remover/Installer on transaxle case at cooler line bracket bolt hole. Press new transaxle cooler line seal in by tightening seal pressing bolt on tool until seal bottoms out in case bore. See Fig 1.
- Install oil cooler line assembly stud into transaxle case using a TORX socket. Install transaxle cooler line assembly to transaxle. Tighten transaxle oil cooler line assembly nut to specification. See TORQUE SPECIFICATIONS . Start engine, warm up transaxle, and check for leaks. Check for proper fluid level. See CHECKING FLUID LEVELS under LUBRICATION.
NOTE:
When installing new cooler line seals, it is important to have installing plunge of the tool centered in transaxle's bore. If plunger is not centered, seal may be installed improperly and a leak would occur.