Diagnostic Procedure
- If auto learn procedure has been performed, go to next step. If auto learn procedure has not been performed, see PROGRAMMING .
- Turn ignition off. Turn parking lights on to maintain BCM in awake state. Connect scan tool. Using scan tool, monitor Passlock(tm) power feedback while cycling ignition on and off. Turn parking lights off. If Passlock(tm) power feedback does not follow ignition cycle, go to next step. If Passlock(tm) power feedback follows ignition cycle, go to step 4.
- Disconnect Passlock(tm) sensor. Using scan tool, monitor Passlock(tm) power feedback voltage. If scan tool indicates HIGH, replace Passlock(tm) sensor. See appropriate STEERING COLUMN SWITCHES article. If scan tool does not indicate HIGH, go to next step. Using DVOM, measure voltage between terminal No. 3 (Red/White wire) at Passlock(tm) sensor connector and ground. If voltage is more than 10 volts, replace BCM. See appropriate BODY CONTROL MODULES article. If voltage is less than 10 volts, repair short to ground in Yellow wire or Orange/Black wire. See WIRING DIAGRAMS .
- Turn ignition on, engine off. Using scan tool, monitor Passlock(tm) voltage. If voltage is less than .4 volt, go to next step. If voltage is more than 4.3 volts, go to step 7. If voltage is .4-4.3 volts, problem is intermittent. See DIAGNOSTIC AIDS .
- Disconnect Passlock(tm) sensor connector. Using scan tool, monitor Passlock(tm) voltage. If volage is not more than 4.3 volts, go to next step. If voltage is more than 4.3 volts, replace Passlock(tm) sensor. See appropriate STEERING COLUMN SWITCHES article.
- Disconnect BCM connector J3. Using DVOM, check for continuity between Yellow wire and ground, and between Yellow wire and Orange/Black wire. If continuity exists, repair short to ground or short to Orange/Black wire. If no continuity exists, replace BCM. See appropriate BODY CONTROL MODULES article.
- Disconnect Passlock(tm) sensor connector. Connect a jumper wire between Yellow wire and Orange/Black wire at Passlock(tm) sensor connector. If voltage is more than .4 volt, go to next step. If voltage is less than .4 volt, go to step 9.
- Remove jumper wire. Using DVOM, measure voltage on Yellow wire at Passlock(tm) sensor connector. If voltage is 4-6 volts, repair open in Orange/Black wire between Passlock(tm) sensor connector and BCM connector J3, terminal B3. If voltage is not 4-6 volts, repair open in Yellow wire between Passlock(tm) sensor connector and BCM connector J3, terminal B7. See WIRING DIAGRAMS .
- Remove jumper wire. Using DVOM, measure voltage on Red/White wire at Passlock(tm) sensor connector. If voltage is more than 10 volts, go to next step. If voltage is less than 10 volts, go to step 11.
- Using DVOM, measure voltage on Yellow wire at Passlock(tm) sensor connector. If voltage is not 4-6 volts, repair Yellow wire for short to voltage or short to Red/White wire. If voltage is 4-6 volts, check connector at Passlock(tm) sensor. Repair as necessary. If connection is okay, replace Passlock(tm) sensor. See appropriate STEERING COLUMN SWITCHES article.
- Turn ignition off. Disconnect BCM connector J3. Using DVOM check for continuity between Red/White wire and ground at Passlock(tm) sensor connector. If continuity exists, repair Red/White wire for short to ground. If continuity does not exist, check connectors at BCM. Repair as necessary. If connections are okay, replace BCM. See appropriate BODY CONTROL MODULES article.