System Operation Check
- Turn ignition switch to RUN position. Observe AIR BAG indicator with air bags installed. If AIR BAG indicator comes on for approximately 6 seconds then goes out, air bag system is functioning properly and no fault codes exist.
- If a fault code is detected in air bag system during system check, AIR BAG indicator will fail to light, stay on continuously or flash.
- The AIR BAG indicator may not start flashing for approximately 30 seconds (16 seconds on Mark VIII) after ignition switch has been turned to RUN position. This time is required for diagnostic monitor to complete test air bag system.
- If AIR BAG indicator is inoperative and a system fault exists, an audible tone of 5 sets of 5 beeps will be heard. If this occurs, air bag system service is required.