LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 1996 >> SC2 Automatic, MP7 >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Diagnosis >> Testing >> DTC P0710 - Low Transaxle Temperature >> Diagnostic Procedure

Diagnostic Procedure

  1. Start and test drive vehicle in 4th gear for at least 30 minutes or until DTC sets. If DTC P0710 sets, go to next step. If DTC P0710 does not set, problem is intermittent. Check all appropriate connections.
    NOTE: Calculated transaxle temperature is an index figure used by PCM for transaxle operation, not true transaxle temperature.
  2. Calculate transaxle temperature using following formula: Engine temperature (°C) + intake air temperature (°C) divided by 2, - 53°C. Disconnect PCM connector J4. Using ohmmeter, measure resistance between terminals B8 and A11. Compare readings with TEMPERATURE SENSOR SPECIFICATIONS table.
  3. If calculated temperature is less than actual sensor temperature reading, replace PCM. If calculated temperature is not less than actual sensor temperature reading, go to next step.
  4. Disconnect sensor connector. Sensor is between pressure filter and cooler line connection. Using ohmmeter, measure resistance between sensor terminals and compare readings with TEMPERATURE SENSOR SPECIFICATIONS table.
  5. If calculated temperature is less than actual sensor temperature reading, inspect continuity of circuits between sensor and PCM. Repair as needed. If calculated temperature is not less than actual sensor temperature reading, replace sensor.
TEMPERATURE SENSOR SPECIFICATIONS

Temperature °F (°C) Ohms
-40 (-40) 93630
-20 (-29) 46352
0 (-18) 24094
20 (-7) 13111
40 (4) 7436
60 (16) 4180
80 (27) 2554
100 (38) 1609
120 (49) 1043
140 (60) 693
160 (72) 456
180 (83) 318
200 (94) 226
220 (105) 165
248 (120) 109
284 (140) 65