Information Flag No. 16 Diagnosis
Scan tester displays EVO output and feedback values to assist in diagnosis of EVO system. When system is operating as it should, the following conditions will occur:
- When no output is generated by PCM (EVO actuator not cycling), output value indicated on Tech 1 scan tester will be 100 percent, and feedback value will be zero percent.
- When output is generated by PCM (EVO actuator cycling), output value will decrease, and input value will increase proportionally. For example, if output is 80 percent, input will be 20 percent, or if output is 20 percent, input will be 80 percent.NOTE: After repairs, cycle ignition on and off once to prevent Information Flag No. 16 from resetting. Also, Information Flag No. 16 may set if a loss of ignition occurs when vehicle is still moving. This condition is normal.CAUTION: To prevent damage to connector terminals, DO NOT probe PCM connector terminals at very end of terminal. Instead, backprobe these terminals, even when PCM connector is disconnected.
- Connect scan tester. Drive vehicle at speed of 30 MPH or more while an assistant monitors EVO feedback. If feedback does not increase as vehicle speed increases, go to next step. If feedback increases as vehicle speed increases, problem is intermittent. Check for cause of intermittent problem (such as poor connections), and check system mechanical condition.
- Turn ignition off. Disconnect PCM 32-cavity connector. See Fig 1. Turn ignition on. Check voltage at terminal C15 (Dark Blue/White wire) of PCM 32-cavity connector.
- If voltage is present, repair short to voltage source in Dark Blue/White wire. If no voltage is present, turn ignition off. Measure resistance between ground and terminal C15 (Dark Blue/White wire) of PCM 32-cavity connector.
- If resistance is less than 200 ohms, repair short to ground in Dark Blue/White wire. If resistance is greater than 200 ohms, measure resistance between ground and terminal C16 (Light Blue/Black wire) of PCM 32-cavity connector.
- If resistance is less than 200 ohms, repair short to ground in Light Blue/Black wire. If resistance is greater than 200 ohms, measure resistance between terminals C15 and C16 (Dark Blue/White and Light Blue/Black wires) of PCM 32-cavity connector.
- If resistance is less than 8 ohms, repair short between Dark Blue/White and Light Blue/Black wires. If resistance is greater than 12 ohms, go to next step. If resistance is 8-12 ohms, check for poor connection at PCM 32-cavity connector. If connector is okay, check PCM operation. Replace PCM if faulty. See TEST W/ CODES article in ENGINE PERFORMANCE.
- Disconnect EVO actuator connector. Check continuity between terminal C16 (Light Blue/Black wire) of PCM 32-cavity connector and Light Blue/Black wire terminal of EVO actuator connector. If there is no continuity, repair open in Light Blue/Black wire.
- If there is continuity, check continuity between terminal C15 (Dark Blue/White wire) of PCM 32-cavity connector and Dark Blue/White wire terminal of EVO actuator connector. If there is no continuity, repair open in Dark Blue/White wire. If there is continuity, check for poor connection at EVO actuator connector. If connector is okay, replace EVO actuator.