EXPERTEC TSB (94-T-05)
Publication date: 1994-02-15Reference number: 94-T-05
EXPERTEC TSB
TECHNICAL SERVICE BULLETIN
ENGINE STUMBLES RUNS ROUGH - OR SURGES DURING START
Model(s): 1991-94 Saturn SC2
Bulletin No.: Saturn 94-T-05
Date: 02/15/1994
BULLETIN ILLUSTRATION LIST
SUBJECT
Engine Stumbles, Runs Rough or Surges During Initial Start-SOHC (LKO) and DOHC (LLO) Engines (Clean Carbon Deposits From Intake Valves)
MODELS AFFECTED
1991-94 Saturns
SERVICE INFORMATION
Some customers may comment that the vehicle may stumble, run rough or surge on initial cold start.
CAUSE
The intake valves may accumulate carbon or fuel deposits due to driving schedules and/or using gasoline without proper fuel additives.
CORRECTION
Perform the following procedures to remove carbon and fuel deposit accumulation.
PROCEDURE: SOHC (LKO) ENGINES
SERVICE PROCEDURE
Chemical Valve Cleaning - SOHC (LKO) Engine
- Run engine until normal operating temperature is obtained.
- Turn ignition Off.
- Disable electronic ignition system by removing "DIS" fuse and remove air cleaner cover.
- Remove valve rocker arm cover and loosen intake valve rocker arm shaft to allow the intake valves to close.
- Pour half the contents of Saturn Top Engine Cleaner (P/N 21007128) or equivalent into the throttle body fuel injector assembly and let soak a minimum of four hours.NOTE: Spark plugs must be removed to prevent engine damage during cranking.
- Remove spark plugs and place rags in front of each spark plug hole.NOTE: Rocker arm tangs (slots) must be properly seated prior to tightening rocker arm shaft bolts or valve and piston damage will occur.
- Uniformly tighten intake valve rocker arm shaft and install valve rocker arm Cover.
Torque: 25 N-m (19 lbs. ft.) - Rocker Arm Shaft
30 N-m (22 lbs. ft.) - Rocker Arm Cover
NOTE: Do not crank engine for longer then 15 seconds at one time or damage to the starter motor could result. - Crank engine 15 seconds, wait one minute, than crank engine for another 15 seconds.
- Remove rags, and install spark plugs and "DIS" fuse.
Torque: 27 N-m (20 lbs. ft.)
- Start engine and allow it to reach normal operating temperature.
- Connect PDT to vehicle and perform special test "MAX IAC. "Slowly pour remaining contents of the Saturn Top Engine Cleaner (P/N 21007128) or equivalent into the throttle body fuel injector assembly.
- Install air cleaner cover.
If the condition still exists, the valves are most likely contaminated with fuel deposits and must be cleaned with the Saturn Carbon Blaster SA9212NE or an equivalent carbon blasting tool. For instructions, refer to "Engine Mechanical Service Manual."
DOHC (LLO) ENGINES
Only oil carbon deposits have been identified on the DOHC (LLO) engine valves and the following procedure must be used.
- Remove front air inlet duct assembly.
- Run engine until normal operating temperature is obtained.
- While engine is running, remove positive crankcase ventilation (PCV) valve (also called the crankcase vent valve assembly) from grommet in camshaft cover assembly. Leave PCV valve attached to the vacuum line.
- Connect PDT to vehicle and perform special test "MAX IAC." Allow complete can of Saturn Top Engine Cleaner (P/N 21007128) or equivalent, to be slowly drawn into the engine through the PCV valve by dipping the PCV valve in and out of the Saturn top engine cleaner.
- Install front air inlet duct assembly and the PCV valve into the grommet in the camshaft cover assembly Verify that the condition has been repaired. If the condition still exists, refer to the appropriate service manual for diagnostic procedures.
PARTS REQUIREMENTS
21007128 Saturn Top Engine Cleaner
CLAIM INFORMATION
To receive credit for this repair, submit a claim through the Saturn Dealer System as follows:
| Case Type | Description | Labor Operation Code | Time |
|---|---|---|---|
| VW | Chemical Valve Cleaning-SOHC Engine | T9659 | 1.3 hrs |
| VW | Chemical Valve Cleaning-DOHC Engine | T9659 | 0.8 hrs |
| VW | Add if required: Clean (Carbon Blaster) Valves, Intake - SOHC Engine | J0400 | 3.4 hrs |