LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 1992 >> SL Automatic >> Repair and Diagnosis >> Quick Lookups >> Technical Bulletins >> Technical Service Bulletins >> HVAC Control Systems >> EXPERTEC TSB (92-T-41-SATURN)

EXPERTEC TSB (92-T-41-SATURN)

Publication date: 1992-08-01
Reference number: 92-T-41-SATURN

EXPERTEC TSB

EXPERTEC TSB

TECHNICAL SERVICE BULLETIN

Reference Number(s): 92-T-41-SATURN, Date of Issue:  08/01/92

WATER/DEBRIS INTRUSION INTO - BLOWER MOTOR (INSTALL SEAL)

Model(s): All 1991 and 1992 Saturns

Subject: Water or Debris Intrusion into Blower Motor (Install Upper Panel Cowl Seal)

Bulletin No.: 92-T-41-SATURN

Date: 08/01/1992

BULLETIN ILLUSTRATION LIST

Fig 1: Graphic
GE00WZ00120
Fig 2: Graphic
GE01WZ00120
Fig 3: Graphic
GE02WZ00120
Fig 4: Graphic
GE03WZ00120
Fig 5: Graphic
GE04WZ00120
Fig 6: Graphic
GE05WZ00120
Fig 7: Graphic
GE06WZ00120

CONDITION

Some owners of 1991-1992 Saturns may hear a loud noise from the HVAC fan when it is running or notice water dripping from blower motor housing.

CAUSE

The grinding or clicking noise may be caused by debris such as leaves or twigs that may have entered the ventilation system and are trapped in the fan housing.

CORRECTIVE ACTION

Inspect fan housing for debris and remove if present.Install upper panel cowl seal at cowl air inlet.

PROCEDURE

  1. Disconnect blower motor connector.
  2. Remove blower motor mounting screws and remove blower motor assembly.
  3. Check the HVAC module for debris through the blower motor opening. Remove any debris from evaporator case.
    NOTE: Use care when removing debris from front of evaporator to prevent damage to the evaporator fins.
  4. Install blower motor and connect electrical connector.
  5. Check right-side, air inlet at cowl for presence of upper cowl barrier foam ring (P/N 21030702). If it is present, remove from vehicle.
    1. Use plastic scraper to remove foam ring.
    2. Use 3M" General Purpose Adhesive Cleaner P/N 051135-08989 (or equivalent) to clean off adhesive.
    3. Check if black adhesive tape (nose patch), shown in Fig 3 that was installed on early 1991 vehicles is present. If present, remove from vehicle.
    4. Apply 3M" Electrical Moisture Sealant P/N 06149 (or equivalent) over 10mm tooling hole.
      NOTE: This seal patch is already present on all 1992 and some late model 1991 vehicles.
  6. Install upper cowl panel seal (P/N 21030781) over right-side air inlet at cowl.
  7. Using template provided (refer to adhesive backed template attached to this bulletin), cut left-side cowl air inlet patch from seal P/N 21039276 and install to cowl. For reference, the template is also shown in an illustration on the next page.

PARTS REQUIREMENTS

CLAIM INFORMATION

To receive credit for this repair, submit a claim through the Saturn Dealer System as follows:

Fig 8: CLAIM INFORMATION TABLE
GB0037973