LEMON Manuals: Even more car manuals for everyone
Home >> Saab >> 2008 >> 9-3 2.0T, 2D Convertible, Automatic >> Repair and Diagnosis >> Electrical >> Charging Systems >> Repair Instructions >> Alternator, Z19 >> To remove

To remove

  1. Remove the battery cover and disconnect the negative battery cable.
    Fig 1: Illustration For Steps 1-2
    G05053991Courtesy of SAAB-SCANIA OF AMERICA, INC.
  2. DTH  Remove the upper engine cover and insulation.
  3. DT:  Remove the generator's upper retaining bolt.

    DTH  Remove the generator's two upper retaining bolts.

    Fig 2: Illustration For Step 3
    G05053992Courtesy of SAAB-SCANIA OF AMERICA, INC.
  4. Raise the car.
  5. Remove the lower engine cover.
    Fig 3: Illustration For Step 5
    G05053993Courtesy of SAAB-SCANIA OF AMERICA, INC.
  6. Remove the front right wheel.
  7. Remove the right-hand FRONT WING LINER .
    Fig 4: Illustration For Step 7
    G05053994Courtesy of SAAB-SCANIA OF AMERICA, INC.
  8. Release the load of the belt tensioner and lock it with 87 92 335 LOCK PIN .
    Fig 5: Illustration For Step 8
    G05053995Courtesy of SAAB-SCANIA OF AMERICA, INC.
  9. Lift the poly-v-belt off the alternator.
    IMPORTANT: Make a note of the belt's direction of rotation. The belt must be refitted for the same direction of rotation as previously.
  10. Remove the bolt from the steering swivel member, lower the suspension arm and place a 83 95 238 WEDGE  between the suspension arm and the anti-roll bar.
    Fig 6: Illustration For Step 10
    G05053996Courtesy of SAAB-SCANIA OF AMERICA, INC.
  11. Tap the drive shaft out of the intermediate shaft with a brass drift and large hammer. Move aside the drive shaft.
    Fig 7: Taping Drive Shaft Out Of Intermediate Shaft
    G05053997Courtesy of SAAB-SCANIA OF AMERICA, INC.
    WARNING: Use protective goggles to protect against flying splinters of metal.
  12. Remove the generator's electrical connections (ring terminals).
    Fig 8: Illustration For Steps 12-14
    G05053998Courtesy of SAAB-SCANIA OF AMERICA, INC.
  13. DT:  Remove the lower bracket.
    Fig 9: Illustration For Step 13
    G05053999Courtesy of SAAB-SCANIA OF AMERICA, INC.

    DTH:  Remove the generator's lower retaining bolt.

  14. Lower the alternator and lift it out.