Section 156 (All-Wheel Drive)
WARNING: This page is about a different car, the 2008 Saab 9-3. However, it is still accessible from the selected car via links, so may be relevant.
- Repair Instructions
- Limited slip differential
- Limited slip differential clutch
- Filter, differential clutch, replacement
- Transfer case, B284
- Transfer case, checking/filling oil
- Transfer case, changing the oil
- Hydraulic pump, differential clutch
- Hydraulic pipe, limited slip differential clutch, replacement
- Propeller shaft
- Complete unit, differential clutch and limited slip differential
- Checking/changing fluid in the differential clutch
- Checking/changing the oil in the limited slip differential
- Bearing, intermediate shaft, replacement
- Cover, differential clutch, replacement
- Intermediate shaft, replacement
- Differential clutch
- Stuffing boxes, O-rings transfer case, replacement
- Control module, incl. solenoid valve (724)
- Seal (stuffing box), driver in differential clutch
- Driver in differential clutch, replacing
- Valve, limited slip differential clutch, replacement
- Front rubber bushings in rear axle, replacement
- Rear rubber bushings in rear axle, replacement
- Description and Operation
- Principal components
- Brief description
- System function
- Hydraulic system
- Transfer case
- Propeller shaft
- Differential clutch
- Limited slip differential
- Limited slip differential clutch (eLSD)
- Lubricants
- Driving
- Control module, all-wheel drive (724)
- Solenoid valve, differential clutch (724a)
- Solenoid valve, limited slip differential clutch (763)
- Engine, hydraulic pump, differential clutch (764)
- Component Locator
- Rear electrical centre 701 (REC)
- Control module, all-wheel drive (724)
- Solenoid valve, limited slip differential clutch (763)
- Crimp J108, main wiring harness
- Crimp J358, main wiring harness 4D/5D
- Connector H10-5
- Grounding point G34P
- Grounding point G34S
- Fuse 11, luggage compartment fuse box 701
- Fuse 17, rear electrical centre 701
- Specifications
- Special Tools and Equipment
- CH-49158 Press tool
- DT-49030 Removal tool
- DT-49035 Holder, propeller shaft
- DT-49048 Support
- DT-49061 Entry cone
- DT-49064 Puller
- DT-49065 Fitting drift
- DT-49068 Fitting drift
- DT-49093 Fitting drift
- DT-49094 Fitting drift
- DT-49095 Fitting drift
- DT-49097 Fitting drift
- DT-49103 Fitting drift
- DT-49104 Protective collar
- DT-49126 Press tool
- DT-49132 Removal tool
- DT-49147 Support
- KM-6313-300 Support
- KM-6314-100 Support
- KM-6314-200 Spacer
- DT-49231 Puller
- Schematic and Routing Diagrams