LEMON Manuals: Even more car manuals for everyone
Home >> Saab >> 2000 >> 9-3 Base, 2D Convertible, Standard >> Repair and Diagnosis >> Transmission >> Clutch System >> Adjustment - Replacement >> Master cylinder LHD >> To remove

To remove

  1. Empty the clutch system (brake fluid) through the bleed nipple on the slave cylinder with 88 19 096 BLEEDING EQUIPMENT 
    Fig 1: Illustration For Step 2-3
    G03505077Courtesy of SAAB-SCANIA OF AMERICA, INC.
  2. Unplug the connector to the bonnet contact for the alarm if fitted.
  3. Undo the main fuse box and put it to one side.
  4. Detach the inlet hose from the master cylinder.
    Fig 2: Illustration For Step 4-7
    G03505078Courtesy of SAAB-SCANIA OF AMERICA, INC.
  5. Undo the clip securing the deliver pipe to the master cylinder.
  6. Pull off the delivery pipe.
  7. Remove the nut in the engine bay securing the right-hand part of the clutch pedal bracket to the bulkhead.
  8. Remove the lower dashboard panel and knee protection from under the steering wheel.
    Fig 3: Illustration For Step 8-9
    G03505079Courtesy of SAAB-SCANIA OF AMERICA, INC.
  9. Remove the floor duct and pedal switch.
  10. Remove the air duct for the side-window defroster and the cable ties on the wiring harness.
    Fig 4: Illustration For Step 10
    G03505080Courtesy of SAAB-SCANIA OF AMERICA, INC.
  11. Remove the locking clip and pin from the clutch pedal.
    Fig 5: Illustration For Step 11-12
    G03505081Courtesy of SAAB-SCANIA OF AMERICA, INC.
  12. Remove the nut securing the clutch pedal.
  13. Lift out the right-hand part of the clutch pedal bracket with the master cylinder.
  14. Undo the nuts securing the master cylinder to the bracket and remove the nuts.
    Fig 6: Illustration For Step 14-15
    G03505082Courtesy of SAAB-SCANIA OF AMERICA, INC.
  15. Remove the master cylinder.