Master cylinder LHD: Fitting
- Make sure the seal is fitted on the master cylinder and fit the cylinder onto the bracket.
Tightening torque 24 N.m (18 lbf ft).
- Position the right-hand clutch pedal bracket with the master cylinder against the bulkhead and the clutch pedal bolt.
- Fit the nut on the clutch pedal bolt without tightening it.
- Make sure the clutch pedal helper spring is fitted correctly.
- Tighten the right-hand clutch pedal bracket to the bulkhead.
Tightening torque 24 N.m (18 lbf ft).
- Connect the inlet hose to the master cylinder.
- Connect the delivery pipe and replace the locking clip.
- Fit the main fuse box and connect the bonnet alarm contact.
- Tighten the nut on the clutch pedal.
Tightening torque 47 N.m (35 lbf ft).
- Fit the pin and locking clip to the pedal.
- Fit the air duct to the side-window defroster and secure the wiring harness.
- Fit the pedal switch.
- Pull up the clutch pedal to adjust the switch to the correct position. If the switch is pressing down on the pedal, it may interfere with the operation.
- Fit the knee protection, floor duct and lower dashboard panel.
- Fill up with brake fluid.
- Bleed the clutch, see BLEEDING THE HYDRAULIC CLUTCH SYSTEM IN THE CAR .
- Test the clutch and cruise control.