LEMON Manuals: Even more car manuals for everyone
Home >> Saab >> 1995 >> 900 S, 2D Convertible, Automatic >> Repair and Diagnosis >> Body & Frame >> Door Locks >> Anti-Theft System >> System Tests >> Functional Tests >> Glass Breakage Sensor Inoperative

Glass Breakage Sensor Inoperative

  1. Connect scan tool. Select READ VALUES, then GLASS BREAK SENSOR. Jingle keys near sensor. If scan tool does not display 10-255, go to next step. If scan tool displays 10-255, retest system. If alarm still does not operate, replace anti-theft control module.
  2. Disconnect glass breakage sensor 4-pin connector. See Fig 1 . Select READ VALUES, then GLASS BREAK SENSOR. Scan tool should display "0". Connect jumper wire between glass breakage sensor connector terminals No. 1 and 2. Scan tool should display 255. If values are not to specification, go to next step. If values are to specification, replace glass breakage sensor.
  3. Disconnect in-line connector between glass breakage sensor and anti-theft control module. See Fig 2 . Scan tool should display "0". Connect jumper wire between in-line connector terminals No. 2 (Blue wire) and No. 3 (Orange wire). Scan tool should display 255. If values are not to specification, check wiring between anti-theft control module and connector. Repair as necessary. If wiring is okay, replace anti-theft control module. If values are to specification, check wiring between connector and glass breakage sensor. Repair as necessary. If wiring is okay, replace glass breakage sensor.
Fig 1: Locating Glass Breakage Sensor & Connector Terminal Identification
G96E09696Courtesy of SAAB-SCANIA OF AMERICA, INC.
Fig 2: Locating In-Line Connector & Connector Terminal Identification
G96G09697Courtesy of SAAB-SCANIA OF AMERICA, INC.