LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 1979 >> 924 Standard Trans >> Repair and Diagnosis >> Maintenance >> Procedures >> Wheel Alignment Specifications & Adjustments >> Adjustment >> Riding Height >> 911 (Front)

911 (Front)

  1. Checking or adjusting riding height can only be performed with vehicle on level surface. Mark center of front wheel hub cap (grease retainer cup). Jounce vehicle several times to settle suspension. Measure distance "A" shown in Fig 1. Measure distance "B" in same figure. Difference between measurements should be as shown in table.
  2. If necessary, loosen or tighten torsion bar adjusting bolt until correct height is obtained. Jounce vehicle several times and recheck height. Make sure difference between right and left side measurements does not exceed 0.20" (5 mm).
RIDING HEIGHT SPECIFICATIONS (1)

Application Front Rear
911/SC 4.25±.20" (108±5mm) .468±.20" (12±5 mm)
Turbo 3.3±.20" (84.5±5 mm) 1.5±.20" (37±5 mm)
(1) Measurement is difference between "A" and "B".
Fig 1: Front Suspension Riding Height Measuring Points
G09352500Courtesy of PORSCHE CARS NORTH AMERICA, INC.