LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2009 >> Vibe GT, Standard >> Repair and Diagnosis >> Body & Frame >> Windows >> Fixed & MOVEABLE Window System >> Repair Instructions >> Windshield Replacement >> Removal Procedure

Removal Procedure

    Fig 1: Windshield Side Garnish Molding
    GM241992Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Before cutting out a stationary window, apply a double layer of masking tape around the perimeter of the painted surfaces and the interior trim.
  1. Open the door.
  2. Remove the windshield inside garnish moldings (1) from the vehicle. Refer to Windshield Pillar Garnish Molding Replacement (Without Roof Side Rail Restraint) or Windshield Pillar Garnish Molding Replacement (With Roof Side Rail Restraint) .
  3. Remove the rearview mirror. Refer to Inside Rearview Mirror Replacement .
  4. CAUTION: If broken glass falls into the defroster outlets, it can be blown into the passenger compartment and cause personal injury.
  5. Cover to protect the following parts from broken glass:
    1. Upper dash pad
    2. Defroster outlets and A/C outlets
    3. Seats and carpeting
  6. Open the hood.
  7. Remove the air inlet grille. Refer to Air Inlet Grille Panel Replacement .
  8. Remove the windshield wiper arms. Refer to Windshield Wiper Arm Replacement .
  9. CAUTION: If a window is cracked but still intact, crisscross the window with masking tape in order to reduce the risk of damage or personal injury.
    CAUTION: When working with any type of glass or sheet metal with exposed or rough edges, wear approved safety glasses and gloves in order to reduce the chance of personal injury.
    Fig 2: Exploded View Of One Piece Or Two Piece Stoppers
    GM2015314Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Depending on vehicles, one piece (1) or two piece (2) stoppers are used on the windshield.
  10. Disconnect the windshield glass stoppers (1) (2), if equipped.
  11. Fig 3: Separating Urethane Adhesive From Window
    GM379881Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Keep the cutting edge of the tool against the window.
  12. This will allow the urethane adhesive to be separated from the window.
    • Leave a base of urethane on the pinchweld flange.
    • The only suitable lubrication is clear water.
    • Use the J 24402-A  , J 39032  , or equivalent in order to remove the window. See Special Tools .
  13. Fig 4: Separating Bottom Of Window
    GM379883Courtesy of GENERAL MOTORS CORP.
  14. Remove the bottom of the window from the urethane adhesive using a long utility knife or similar tool.
  15. Fig 5: Removing/Installing Windshield
    GM441419Courtesy of GENERAL MOTORS CORP.
  16. Remove the windshield (1) from the vehicle with the aid of an assistant (2).
  17. Fig 6: Identifying Windshield Glass Adhesive Dam
    GM2015320Courtesy of GENERAL MOTORS CORP.
  18. Remove the windshield glass adhesive dam (1).
  19. Fig 7: View Of One Piece Windshield Glass Stopper
    GM2015321Courtesy of GENERAL MOTORS CORP.
  20. Remove the one piece windshield glass stopper (1), if equipped.
  21. Fig 8: Exploded View Of Two Piece Windshield Glass Stopper
    GM2015322Courtesy of GENERAL MOTORS CORP.
  22. Remove the two piece windshield glass stopper (1), if equipped.