LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2008 >> Vibe Automatic >> Repair and Diagnosis >> Brakes >> Anti-Lock Brake System, Traction Control System & Stability Control System >> Diagnostic Information and Procedures >> DTC C1224 >> Test Description

Test Description

The number below refers to the step number on the diagnostic table.

  1. 2:  Test the engine RPM signal circuits of the EBCM for a high resistance, an open, or a short.
Step Action Value(s) Yes No
Schematic Reference: Antilock Brake System Schematics 
Connector End View Reference: Antilock Brake System Connector End Views 
1 Did you perform the Diagnostic System Check - Vehicle? - Go to Step 2  Go to Diagnostic System Check - Vehicle
2  Test the engine RPM signal circuit of the electronic brake control module (EBCM) for a high resistance, an open, or a short. Refer to Circuit Testing and Wiring Repairs .
Did you find and correct the condition?
- Go to Step 7  Go to Step 3 
3
  1. Disconnect the EBCM connector.
  2. Turn ON the ignition, with the engine OFF.
  3. Measure the voltage of the engine RPM signal circuit of the EBCM to a good ground. Refer to Circuit Testing and Wiring Repairs .
Is the voltage as specified?
10-14 V or below 1 V Go to Step 4  Go to Step 5 
4
  1. Disconnect the EBCM connector.
  2. Turn ON the ignition, with the engine running.
  3. Measure the voltage of the engine RPM signal circuit of the EBCM to a good ground. Refer to Circuit Testing and Wiring Repairs .
Is the voltage as specified?
10-14 V and pulsing below 1 V Go to Step 6  Go to Step 5 
5 Replace the powertrain control module (PCM). Refer to Powertrain Control Module Replacement .
Did you complete the replacement?
- Go to Step 7  -
6 Inspect for poor connections at the EBCM and PCM connectors. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs .
Did you find and correct the condition?
- Go to Step 7  Go to Step 2 
7
  1. Use the scan tool in order to clear the DTCs.
  2. Operate the vehicle within the Conditions for Running the DTC, as specified in the supporting text.
Does the DTC reset?
- Go to Step 2  System OK