LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2008 >> Vibe Automatic >> Repair and Diagnosis >> Brakes >> Anti-Lock Brake System, Traction Control System & Stability Control System >> Diagnostic Information and Procedures >> DTC C0371 >> Test Description

Test Description

The number below refers to the step number on the diagnostic table.

  1. 4:  Test the deceleration sensor ground circuit for a high resistance or an open.
Step Action Value(s) Yes No
Schematic Reference:  Antilock Brake System Schematics  
Connector End View Reference:  Antilock Brake System Connector End Views  
1 Did you perform the Diagnostic System Check - Vehicle? - Go to Step 2  Go to Diagnostic System Check - Vehicle
2 Is U0073, U0123, U0124, or U0126 also set? - Go to Diagnostic Trouble Code (DTC) List - Vehicle Go to Step 3 
3
  1. Disconnect the yaw rate sensor connector.
  2. Turn ON the ignition, with the engine OFF.
  3. Measure the voltage of the yaw rate sensor ignition positive voltage circuit to a good ground. Refer to Circuit Testing and Wiring Repairs .
Is the voltage within the specified range?
10-14 V Go to Step 4  Go to Step 5 
4  Test the yaw rate sensor ground circuits of the electronic brake control module (EBCM) for a high resistance or an open. Refer to Circuit Testing and Wiring Repairs .
Did you find and correct the condition?
- Go to Step 7  Go to Step 6 
5 Locate and repair the following in ignition positive voltage circuit of deceleration sensor.
  • An open
  • High resistance
  • Short to ground

Did you find and correct the condition?
- Go to Step 7  -
6 Replace the yaw rate sensor. Refer to Vehicle Yaw Sensor Replacement .
Did you complete the replacement?
- Go to Step 7  -
7
  1. Use the scan tool in order to clear the DTCs.
  2. Operate the vehicle within the Conditions for Running the DTC, as specified in the supporting text.
Does the DTC reset?
- Go to Step 2  System OK