LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2008 >> Vibe Automatic >> Repair and Diagnosis >> Brakes >> Anti-Lock Brake System, Traction Control System & Stability Control System >> Diagnostic Information and Procedures >> DTC C0279 >> Test Description

Test Description

The number below refers to the step number on the diagnostic table.

  1. 2:  This step determines if the DTC is current.
Step Action Values Yes No
Schematic Reference:  Antilock Brake System Schematics  
Connector End View Reference:  Antilock Brake System Connector End Views  
1 Did you perform the Diagnostic System Check - Vehicle? - Go to Step 2  Go to Diagnostic System Check - Vehicle
2 
  1. Install a scan tool.
  2. Turn ON the ignition, with the engine OFF.
  3. Use the scan tool in order to clear the DTCs.
  4. Using the scan tool, cycle the solenoid valves in the Special Functions menu.
  5. Read the DTCs.
Does the DTC reset?
- Go to Step 3  Go to Diagnostic Aids 
3
  1. Turn OFF the ignition.
  2. Disconnect the electronic brake control module (EBCM) harness connector.
  3. Measure the voltage between the battery positive voltage circuits of the EBCM and a good ground.
Does the voltage measure as specified?
10-14 V Go to Step 4  Go to Step 5 
4 Measure the resistance between the EBCM ground circuits and a good ground.
Does the resistance measure as specified?
Below 1 Ω Go to Step 7  Go to Step 6 
5 Locate and repair the following in the battery positive voltage circuit.
  • An open
  • High resistance
  • Short to ground

Refer to Circuit Testing and Wiring Repairs .
Did you find and correct the condition?
- Go to Step 8  -
6 Locate and repair the open or high resistance in the motor ground circuit. Refer to Circuit Testing and Wiring Repairs .
Did you find and correct the condition?
- Go to Step 8  -
7 Replace the brake pressure modulator valve (BPMV). Refer to Brake Modulator Assembly Replacement (With VSC)  or Brake Modulator Assembly Replacement (Without VSC) .
Did you complete the replacement?
- Go to Step 8  -
8
  1. Use the scan tool in order to clear the DTCs.
  2. Operate the vehicle within the Conditions for Running the DTC, as specified in the supporting text.
Does the DTC reset?
- Go to Step 2  System OK