Test Description
The numbers below refer to the step numbers on the diagnostic table.
- 2: This step determines if the DTC is current.
- 6: This step tests the relay circuits between the ABS relay block and the EBCM for an open, high resistance, or short to ground.
- 7: This step tests the battery positive voltage circuit for an open, high resistance, or short to ground.
- 8: This step tests the motor ground circuit for an open or high resistance.
| Step | Action | Values | Yes | No |
|---|---|---|---|---|
| Schematic Reference: Antilock Brake System Schematics Connector End View Reference: Antilock Brake System Connector End Views |
||||
| 1 | Did you perform the Diagnostic System Check - Vehicle? | - | Go to Step 2 | Go to Diagnostic System Check - Vehicle |
| 2 |
|
- | Go to Step 3 | Go to Diagnostic Aids |
| 3 | Is the vehicle equipped with the traction control system? | - | Go to Step 4 | Go to Step 5 |
| 4 |
|
10-14 V | Go to Step 6 | Go to Step 7 |
| 5 |
|
10-14 V | Go to Step 8 | Go to Step 9 |
| 6 | Test the relay circuits between the ABS relay block and the EBCM for the following:
Refer to Circuit Testing and Wiring Repairs . Did you find and correct the condition? |
- | Go to Step 14 | Go to Step 11 |
| 7 | Test the battery positive voltage circuit for the following:
Refer to Circuit Testing and Wiring Repairs . Did you find and correct the condition? |
- | Go to Step 14 | Go to Step 12 |
| 8 | Measure the resistance between the EBCM ground circuits and a good ground. Does the resistance measure as specified? |
Below 1 Ω | Go to Step 13 | Go to Step 10 |
| 9 | Locate and repair the following in the battery positive voltage circuit.
Refer to Circuit Testing and Wiring Repairs . Did you find and correct the condition? |
- | Go to Step 14 | - |
| 10 | Locate and repair the open or high resistance in the motor ground circuit. Refer to Circuit Testing
and Wiring Repairs
. Did you find and correct the condition? |
- | Go to Step 14 | - |
| 11 | Replace the ABS motor relay. Did you complete the replacement? |
- | Go to Step 14 | - |
| 12 | Replace the ABS cutoff relay. Did you complete the replacement? |
- | Go to Step 14 | - |
| 13 | Replace the brake pressure modulator valve (BPMV). Refer to Brake Modulator Assembly Replacement (With VSC) or Brake Modulator Assembly Replacement (Without VSC) . Did you complete the replacement? |
- | Go to Step 14 | - |
| 14 |
|
- | Go to Step 2 | System OK |