LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2007 >> Solstice Base, Standard >> Repair and Diagnosis >> Transmission >> Manual Transmission >> Repair Instructions >> Transmission Input Shaft Bearing Retainer Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Sealant Area On Input Shaft Bearing Retainer
    GM881220Courtesy of GENERAL MOTORS CORP.
  1. Apply a 3 mm (1/8 in) bead of sealant GM P/N 89020326 (Canadian P/N 89021188) to the input shaft bearing retainer.
    2. Fig 2: Input Shaft Bearing Retainer
    GM1604434Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Ensure the seal does not catch on the input shaft splines.
  2. Position the input shaft bearing retainer to the transmission.
  3. Apply pipe sealant GM P/N 12346004 (Canadian P/N 10953480) to the threads of the input shaft bearing retainer bolts if new bolts are not available.
    4. NOTE: Refer to Fastener Notice .
  4. Install the NEW input shaft bearing retainer bolts.

    Tighten:  Tighten the input shaft bearing retainer bolts to 17 N.m (13 lb ft).

  5. Install the clutch actuator cylinder. Refer to Clutch Actuator Cylinder Replacement .
  6. Install the transmission to the vehicle. Refer to Transmission Replacement .

    Fill the transmission fluid. Refer to Transmission Fluid Replacement .

scientia non olet · About LEMON Manuals