LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2007 >> Solstice Base, Automatic >> Repair and Diagnosis >> Electrical >> Horns >> Horn System >> Diagnostic Information and Procedures >> Horns Inoperative >> Circuit/System Testing

Circuit/System Testing

  1. Ignition OFF, disconnect the horn relay.
  2. Ignition ON, very that a test lamp does not illuminate between the coil control circuit terminal and ground.
    • If the test lamp illuminates, test the control circuit for a short to voltage.
  3. Verify that a test lamp illuminates between the coil side B+ circuit terminal and ground.
    • If the test lamp does not illuminate, test the B+ circuit for a short to ground or an open/high resistance. If the circuit tests normal and the HORN fuse is open, test the horn control circuit terminal for a short to ground. If the circuit tests normal, test or replace the HORN relay.
  4. Verify that a test lamp illuminates between the switch side B+ circuit terminal and ground.
    • If the test lamp does not illuminate, test the switch side B+ circuit for an open/high resistance.
  5. Ignition OFF, disconnect the harness connector at the horn assembly.
  6. Test for less than 1.0 ohm of resistance between the horn ground circuit terminal A and ground.
    • If greater than the specified range, test the ground circuit for an open/high resistance.
  7. Connect the harness connector at the horn assembly.
  8. Connect a 10A fused jumper wire between the switch side B+ circuit terminal and the horn control circuit terminal. Verify the horn is activated.
    • If the horn does not activate, test the horn control circuit for an open/high resistance. If the circuit tests normal, test or replace the horn assembly.
  9. Disconnect the harness connector C2 at the steering wheel.
  10. Test for less than 1.0 ohm of resistance between the horn switch ground circuit terminal A and ground.
    • If greater than the specified range, test the ground circuit for an open/high resistance.
  11. Connect the harness connector C2 at the steering wheel.
  12. Ignition ON, Connect a test lamp between the coil side B+ circuit terminal and the coil control circuit terminal.
  13. Depress the horn pad. The test lamp should turn ON and OFF when pressing and releasing the horn pad.
    • If the test lamp is always ON, test the coil control circuit for a short to ground. If the circuit tests normal, replace the horn switch.
    • If the test lamp is always OFF, test the control circuit for a short to voltage or an open/high resistance. If the circuit tests normal, replace the horn switch.
  14. Command the horn ON and OFF with a scan tool. The test lamp should turn ON and OFF when changing between the commanded states.
    • If the test lamp is always OFF, replace the BCM.
  15. If all circuits test normal, test or replace the HORN relay.