LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2006 >> Solstice Automatic >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - 2.4L - Introduction (2 Of 2) >> Repair Instructions >> Heated Oxygen Sensor Replacement - Position 1 >> Removal Procedure

Removal Procedure

NOTE: The oxygen sensor uses a permanently attached pigtail and connector. Do not remove the pigtail from the oxygen sensor. Damage to or removal of the pigtail connector could affect proper operation of the oxygen sensor.
NOTE: The use of excessive force may damage the threads in the exhaust manifold/pipe.
IMPORTANT: The in-line connector and louvered end must be kept clear of grease, dirt or other contaminants. Avoid using cleaning solvents of any type. DO NOT drop or roughly handle the heated oxygen sensor (HO2S).
IMPORTANT: The HO2S may be difficult to remove when the engine temperature is less than 48°C (120°F).
    Fig 1: CPA Retainer
    GM1592538Courtesy of GENERAL MOTORS CORP.
  1. Remove the connector position assurance (CPA) retainer.
  2. Disconnect the HO2S electrical connector (2).
  3. Fig 2: HO2S Electrical Connector
    GM1593747Courtesy of GENERAL MOTORS CORP.
  4. Remove the HO2S electrical connector clip from the junction block bracket.
  5. Remove the HO2S (1).