LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2006 >> Solstice Automatic >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - 2.4L - Introduction (2 Of 2) >> Repair Instructions >> Fuel Hose/Pipes Replacement - Chassis >> Installation Procedure

Installation Procedure

    Fig 1: Retaining Clips
    GM1594606Courtesy of GENERAL MOTORS CORP.
  1. Position and install the fuel feed pipe to the vehicle.
  2. Install the fuel feed pipe to the retaining clips at the left rear floor panel tunnel brace.
  3. Close the retaining clips.
  4. Fig 2: Fuel Feed Pipe
    GM1594370Courtesy of GENERAL MOTORS CORP.
  5. Connect the fuel feed pipe (2) quick connect fitting at the fuel tank feed pipe. Refer to Quick Connect Fitting(s) Service (Plastic Collar) .
  6. Fig 3: Pipe Retaining Clips
    GM1594573Courtesy of GENERAL MOTORS CORP.
  7. Install the fuel feed pipe to the retaining clips along the floor panel.
  8. Close the pipe retaining clips.
  9. Lower the vehicle.
  10. Fig 4: Fuel Feed & EVAP Pipe Clip
    GM1590485Courtesy of GENERAL MOTORS CORP.
  11. Install the fuel feed and EVAP pipe clip to the oil level indicator tube bracket.
  12. Fig 5: Fuel Pipe & Fuel Rail
    GM1592525Courtesy of GENERAL MOTORS CORP.
  13. Remove the caps or plugs from the fuel pipe and the fuel rail.
  14. Connect the fuel feed pipe (2) to the fuel rail. Refer to Quick Connect Fitting(s) Service (Metal Collar) .
  15. Connect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure .
  16. Inspect for fuel leaks using the following procedure:
    1. Turn ON the ignition, with the engine OFF for 2 seconds.
    2. Turn OFF the ignition for 10 seconds.
    3. Turn ON the ignition, with the engine OFF.
    4. Inspect for fuel leaks.