LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2005 >> Pursuit Base, Automatic >> Repair and Diagnosis >> Engine Mechanical >> Engine Exhaust System >> Repair Instructions >> Wheel Drive Shaft Heat Shield Replacement >> Installation Procedure

Installation Procedure

    Fig 1: View Of Wheel Drive Shaft Heat Shield
    GM878832Courtesy of GENERAL MOTORS CORP.
  1. Install the wheel drive shaft heat shield into position on the vehicle.
  2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the wheel drive shaft heat shield-to-engine block bolt.

    Tighten:  Tighten the bolt to 30 N.m (22 lb ft).

  4. Install the wheel drive shaft heat shield-to-transmission mount bracket bolt.

    Tighten:  Tighten the bolt to 10 N.m (89 lb in).

  5. Lower the vehicle.