Charge Indicator Inoperative
Charge Indicator Inoperative
| Step | Action | Values | Yes | No |
|---|---|---|---|---|
| Schematic Reference: Starting and Charging Schematics Connector End View Reference: Engine Electrical Connector End Views |
||||
| 1 | Did you perform the Diagnostic System Check - Vehicle? | - | Go to Step 2 | Go to Diagnostic System Check - Vehicle in Vehicle DTC Information |
| 2 | Turn ON the ignition, with the engine OFF. Does the battery charge indicator illuminate? |
- | Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems | Go to Step 3 |
| 3 |
|
- | Go to Step 4 | Go to Step 6 |
| 4 | Test the generator turn on signal circuit for a high resistance or open. Refer to Circuit Testing
and Wiring Repairs
in Wiring Systems. Did you find and correct the condition? |
- | Go to Step 9 | Go to Step 5 |
| 5 | Inspect for poor connections at the harness connector of the engine control module (ECM). Refer to Testing for Intermittent Conditions and Poor Connections
and Connector Repairs
in Wiring Systems. Did you find and correct the condition? |
- | Go to Step 9 | Go to Step 7 |
| 6 | Inspect for poor connections at the harness connector of the instrument panel cluster (IPC). Refer to Testing for Intermittent Conditions and Poor Connections
and Connector Repairs
in Wiring Systems. Did you find and correct the condition? |
- | Go to Step 9 | Go to Step 8 |
| 7 | Replace the engine control module (ECM). Refer to Control Module References
in Computer/Integrating Systems for replacement, setup, and programming. Did you complete the replacement? |
- | Go to Step 9 | - |
| 8 | Replace the IPC. Refer to Control Module References
in Computer/Integrating Systems for replacement, setup, and programming. Did you complete the replacement? |
- | Go to Step 9 | - |
| 9 | Operate the system in order to verify the repair. Did you correct the condition? |
- | System OK | Go to Step 2 |