LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2005 >> GTO Standard >> Repair and Diagnosis >> Electrical >> Charging Systems >> Battery, Charging System And Starting System >> Diagnostic Information and Procedures >> Charge Indicator Always On

Charge Indicator Always On

Charge Indicator Always On

Step Action Value Yes No
Schematic Reference: Starting and Charging Schematics 
Connector End View Reference:  Engine Electrical Connector End Views  
1 Did you perform the Diagnostic System Check - Vehicle? - Go to Step 2  Go to Diagnostic System Check - Vehicle in Vehicle DTC Information
2 Start the engine.
Does the charge indicator remain illuminated?
- Go to Step 3  Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems
3
  1. Install a scan tool.
  2. With a scan tool, observe the Battery Voltage parameter in the instrument panel cluster (IPC) data list.
Does the voltage measure within the normal operating range?
10.5-17.5 V Go to Step 4  Go to Charging System Test 
4 With a scan tool, command the charge indicator lamp On and Off.
Does the charge indicator turn On and Off with each command?
- Go to Step 5  Go to Step 6 
5 Inspect for poor connections at the harness connector of the engine control module (ECM). Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems.
Did you find and correct the condition?
- Go to Step 9  Go to Step 7 
6 Inspect for poor connections at the harness connector of the IPC. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems.
Did you find and correct the condition?
- Go to Step 9  Go to Step 8 
7 Replace the engine control module (ECM). Refer to Control Module References in Computer/Integrating Systems for replacement, setup, and programming.
Did you complete the replacement?
- Go to Step 9  -
8 Replace the IPC. Refer to Control Module References in Computer/Integrating Systems for replacement, setup, and programming.
Did you complete the replacement?
- Go to Step 9  -
9 Operate the system for which the symptom occurred.
Did you correct the condition?
- System OK Go to Step 2