Installation Procedure

Fig 1: View Of Shifter Fasteners

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the shifter fasteners.
Tighten: Tighten the shifter fasteners to 9 N.m (79 lb in).
Connect the shifter assembly electrical wire harness connector.

Fig 2: View Of Park Lock Cable Terminal

Courtesy of GENERAL MOTORS CORP.

Insert the park lock cable terminal onto the park lock cam on the shifter.
Slide the park lock cable into the shifter and assure that the cable locking tab is fully engaged.

Fig 3: View Of Lock Release & Transaxle Range Selector Cable

Courtesy of GENERAL MOTORS CORP.

Snap the shift cable terminal onto the shifter pin.
Insert the shift cable (2) into the shifter base.
Install the shift cable retaining clip (1).
Adjust the shift cable as follows.
1. Place the shifter into the N (neutral) position.
2. Loosen the shifter adjuster nut.
3. Tighten the adjuster nut.
  Tighten: Tighten the adjuster nut to 25 N.m (18 lb ft).
Install the console trim plate. Refer to Trim Plate Replacement - Console in Instrument Panel, Gages and Console.