LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2004 >> Bonneville GXP >> Repair and Diagnosis >> Body & Frame >> Windows >> Door System, Mirror System & Window System >> Repair Instructions >> Window Channel Replacement - Front Side Rear >> Installation Procedure

Installation Procedure

    Fig 1: Locating Upper Run Channel/Lower Door Applique Fastener
    GM441807Courtesy of GENERAL MOTORS CORP.
  1. Insert the run channel into the door through the front access hole.
  2. Slide the run channel up along the window, making sure the upper portion is under the door frame applique and the water shield is against the rearward surface of the inner door panel above the latch.
  3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  4. Install the lower fastener (2).

    Tighten:  Tighten the lower fastener to 9 N.m (80 lb in).

  5. Fig 2: Locating Lower Rear Portion Of Window Seal In Door Frame
    GM441943Courtesy of GENERAL MOTORS CORP.
  6. Lower the window to the full down position.
  7. Pull out enough of the lower rear edge of the window seal to install the upper fastener in the run channel and door applique.
  8. Install the fastener.

    Tighten:  Tighten the fastener to 2 N.m (18 lb in).

  9. Fig 3: Cutaway View Of Weather Strip
    GM489783Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: When reusing the window weatherstrip, the flange mounting area (1) must be pinched together to counteract the splaying effect when removed. Use thumb and index finger to pinch the carrier (2) back together. Work from one end of the weatherstrip to the other.
  10. Reinstall the window weatherstrip into the door frame.
  11. Install the window inner belt seal. Refer to Sealing Strip Replacement - Front Door Window Belt Inner .
  12. Install the water deflector. Refer to Water Deflector Replacement - Front Door .
  13. Install the door trim panel. Refer to Trim Panel Replacement - Side Front Door .