Hard Starting (Hot Or Cold)
- Ensure that customer is using correct starting procedure. Check for contaminated fuel. Test for high resistance in coolant temperature sensor circuit. Visually check TPS for sticking or binding. Ensure fuel pressure is 9-13 psi (.6-.9 kg/cm2 ) at all operating ranges.
- Fuel pressure leak-down after ignition is turned off should be gradual. Immediate drop in pressure indicates leaking in-tank fuel pump coupling, hose or check valve. To check for faulty in-tank fuel pump check valve, turn ignition off. Disconnect fuel line at filter and remove fuel tank cap. Connect radiator test pump to line and apply 15 psi (1 kg/cm2 ). If pressure holds for one minute, check valve is okay.
- Check fuel pump relay. Disconnect oil pressure switch. If engine cranks but will not start, perform fuel system diagnosis. Check injector. With injector harness connector disconnected, check for fuel leakage while cranking. Check cranking circuit.