No Start Test No 8 - Spark Control CKT (Check For Code 43)
- Connect tester to diagnostic connector. Enter Diagnostic Test Mode. Refer to ENTERING ON-BOARD DIAGNOSTICS in this article. Turn ignition off. Disconnect ignition coil wire at distributor and position it a maximum of 1/4" from ground. Disconnect 60-pin connector from SMEC. Connect one end of a jumper wire to cavity No. 34 of connector. Turn ignition on. Press and hold "ATM" key on tester. Touch other end of jumper wire to ground, make and break this connection at ground several times while checking for spark at ignition coil wire.
- If there is spark at ignition coil wire, replace SMEC for a defective logic board. Before replacing SMEC, ensure cavity No. 34 of 60-pin connector is not damaged causing a poor connection. If there is no spark, go to next step.
- Turn ignition off. Remove jumper wire from cavity No. 34 of 60-pin connector. Disconnect 14-pin connector from SMEC. Connect an ohmmeter between cavity No. 34 of 60-pin connector and cavity No. 13 of 14-pin connector. If ohmmeter is reading continuity, replace SMEC for a bad power board. Before replacing SMEC, ensure cavity No. 13 of 14-pin connector is not damaged causing a poor connection. If ohmmeter is not reading continuity, repair Yellow wire of cavity No. 13 in 14-pin connector for an open circuit.