LEMON Manuals: Even more car manuals for everyone
Home >> Plymouth >> 1988 >> Voyager Base, Standard >> Repair and Diagnosis >> Engine Performance >> System >> 3.0L CEC System >> DRIVEABILITY Tests >> DRIVEABILITY Test No 6 - Charge Temperature Sensor CKT (Code 23)

DRIVEABILITY Test No 6 - Charge Temperature Sensor CKT (Code 23)

  1. With tester connected to diagnostic connector, disconnect charge temperature sensor connector. Put system in Sensor Test "03". Refer to ENTERING ON-BOARD DIAGNOSTICS  in this article. If display on tester reads 5 volts, go to next step. If display on tester reads zero volts or zero volts and then increases, replace SMEC. Before replacing SMEC, ensure cavity No. 21 of 60-pin connector is not shorted to ground.
    Fig 1: Charge Temperature Sensor
    G12183
  2. Connect a jumper wire between Black/Red and Black/Lt. Blue wire terminals of charge temperature sensor harness connector. If display on tester reads zero volts, replace charge temperature sensor. If display on tester reads 5 volts, go to next step.
    Fig 2: Jumper Connection on Charge Temperature Sensor
    G12187
  3. Connect one end of a jumper wire to ground. Connect other end of wire to Black/Red wire terminal of throttle body temperature sensor connector. If display on tester reads zero volts, repair Black/Lt. Blue wire of charge temperature sensor connector for an open circuit to wiring harness splice. If display on tester reads 5 volts, repair wire of charge temperature sensor connector for an open circuit to SMEC.
Fig 3: Jumper Connection on Charge Temperature Sensor
G12186