LEMON Manuals: Even more car manuals for everyone
Home >> Plymouth >> 1988 >> Voyager Base, Standard >> Repair and Diagnosis >> Engine Performance >> System >> 2.5L CEC System >> No Start (NS) Tests >> NS7 - Ignition Control Circuit Check

NS7 - Ignition Control Circuit Check

  1. Connect DRB II to engine harness connector. Connect analog voltmeter to positive terminal of ignition coil and ground. Put system in ATM Test Mode 01. If voltmeter is within one volt of battery voltage, go to next step. If voltmeter indicates zero, repair Dark Green/Black tracer wire of coil positive terminal for an open circuit to wiring harness splice.
    Fig 1: Ohmmeter Connection Between Ignition Coil And 14-Pin Connector
    G11939
  2. Connect voltmeter to ignition coil negative terminal (Black/Yellow) and ground. If voltmeter reading is pulsating between 10-14 volts, replace ignition coil. If voltmeter is not pulsating, but reads above 10 volts, go to next step 3). If voltmeter is pulsating between 5-10 volts, replace ignition coil. If voltmeter is pulsating between zero and 2 volts, go to step 4).
  3. Turn ignition off and unplug 14-way connector from SMEC. Connect an ohmmeter between negative terminal of ignition coil and cavity No. 12 of 14-way connector. If ohmmeter is showing continuity, power board is defective. Replace engine control module. If ohmmeter is not showing continuity, check Black/Yellow tracer wire of cavity No. 12 for open circuit. Repair or replace as necessary.
    Fig 2: Ohmmeter Connection to No. 12 of 14-Pin Connector
    G71982
  4. With DRB II connected to engine harness connector, turn ignition off. Disconnect wire from negative side of ignition coil. connect voltmeter to negative terminal of ignition coil and ground. Place system in ATM Test Mode 01. If voltmeter reading is above 10 volts, go to next step. If voltmeter reads between zero and 2 volts, replace ignition coil.
  5. Disconnect coil negative wire and turn ignition off. Unplug 14-way connector from engine control module. Connect an ohmmeter between cavity No. 12 of 14-way connector and ground. If ohmmeter is not showing continuity, power board is defective. Replace engine control module. If ohmmeter is showing continuity, check Black/Yellow tracer wire of cavity No. 12 for short to ground.