LEMON Manuals: Even more car manuals for everyone
Home >> Plymouth >> 1988 >> Voyager Base, Standard >> Repair and Diagnosis >> Engine Performance >> System >> 2.5L CEC System >> No Start (NS) Tests >> NS12, Code 27 - Fuel Control Circuit

NS12, Code 27 - Fuel Control Circuit

  1. Connect diagnostic readout tool to engine control module harness connector. Turn ignition off and remove air cleaner. Unplug 60-way connector from engine control module. Connect one end of jumper wire to cavity No. 33. Plug in injector connector and turn ignition switch to "ON" position. Press ATM button on readout tool. Rapidly connect and disconnect other end of jumper wire to positive terminal of battery post. If fuel sprays from injector, logic board is defective. Replace engine control module. If fuel does not spray from injector, go to next step.
    Fig 1: Voltmeter Connection to Fuel Injector Connector
    G11947
  2. Turn ignition off and unplug 14-way connector from engine control module. Connect an ohmmeter between cavity No. 33 of 60-way connector and cavity No. 8 of 14-way connector. If ohmmeter is indicating continuity, power board is defective. Replace engine control module. If ohmmeter does not indicate continuity, check wire in cavity No. 8 of 14-way connector for open circuit to 60-way connector. Before replacing SMEC, ensure that all terminals and connectors are not damaged causing an poor connection.
Fig 2: Ohmmeter Connection Between 14 and 60-Pin Connectors
G11949