LEMON Manuals: Even more car manuals for everyone
Home >> Plymouth >> 1988 >> Voyager Base, Standard >> Repair and Diagnosis >> Engine Performance >> Adjustment >> Tune-Up - V6 >> Adjustments >> Ignition Timing

Ignition Timing

CAUTION: Do not puncture cables, boots or nipples with test probes. Use proper adapters. Probe can separate conductor and cause high resistance. In addition, breaking rubber insulator may permit secondary current to arc to ground.
  1. Set gear shift selector in "Park" or "Neutral" and apply parking brake. Turn off all lights and accessories. Connect power timing light to No. 1 cylinder or use magnetic timing probe equipment.
  2. Start engine and run until normal operating temperature is reached. Disconnect coolant temperature sensor wires. The I/P lamp should come on. Ensure engine is running at or below curb idle RPM. Aim timing light at timing marks or read magnetic timing unit.
    IGNITION TIMING SPECIFICATIONS (DEGREES BTDC @ RPM)

    Application Man. Trans. Auto. Trans.
    3.0L MPFI
    Initial N/A 12 @ 800
    Total N/A 38 +/- 4 @ 2000
    3.9L TBI 10 @ 750 10 @ 750
  3. If timing is not within +/-2 degrees of specification, loosen distributor hold-down and rotate distributor to obtain correct timing. Tighten distributor hold-down when timing is correct. Turn engine off. Reconnect coolant temperature wire connector and erase fault code.