All Memory, Seat & Mirror Functions Inoperative
- If diagnostic system check was performed, go to next step. If diagnostic system check was not performed, go to DIAGNOSTIC SYSTEM CHECK .
- Disconnect memory seat/mirror control module Black 2-pin connector C2. Using DVOM, check voltage between memory seat/mirror control module harness connector C2 terminal "A" (Orange wire) and ground. If reading is about 12 volts, go to next step. If reading is not about 12 volts, go to step 5).
- Check voltage between memory seat/mirror control module harness connector C2 terminals "A" (Orange wire) and "B" (Black wire). If reading is about 12 volts, go to next step. If reading is not about 12 volts, go to step 6).
- Replace memory seat/mirror control module. See MEMORY SEAT/MIRROR CONTROL MODULE under REMOVAL & INSTALLATION. Perform DIAGNOSTIC SYSTEM CHECK .
- Repair open or short to ground in Orange wire between memory seat/mirror control module connector C2 and right rear power distribution center fuse block No. 2. Perform DIAGNOSTIC SYSTEM CHECK .
- Repair open in Black wire between memory seat/mirror control module connector C2 and ground. Perform DIAGNOSTIC SYSTEM CHECK .