Chart A, Loss Of IPC Display (CRT Equipped)
Loss of IPC display and messages can result from following:
* Loss of 12 volts to IPC.
* Loss of ground to IPC.
* Loss of wake-up signal from BCM.
* Internal BCM or IPC fault.
NOTE:
Test numbers refer to numbers on diagnostic chart.
- This step checks to see if BCM is functioning.
- This step checks BCM power and ground sources.
- This step checks for ignition source, BCM power and ground to IPC. With ignition on, battery voltage should be present at listed terminals.
- Checks for short to ground in any 640 circuit.
- This step checks to see if short to ground is inside a component or in circuit itself.
- This step checks to see if IPC is receiving wake-up signal from BCM.