LEMON Manuals: Even more car manuals for everyone
Home >> Oldsmobile >> 1990 >> Toronado Base, 440T4/ME9 >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - Tests W/Codes - ECM >> Manual Operation Of Service Mode >> ECM Snapshot (CRT Equipped Vehicles)

ECM Snapshot (CRT Equipped Vehicles)

NOTE: If directed here from TEST TYPE SELECTION, go to step 2).
  1. SNAPSHOT allows the recall of system operating specifications present at the exact time an ECM malfunction code was set. Up to 3 snapshots may be recalled. In addition, one snapshot may be triggered on demand. To enter snapshot, complete the following:
    • Enter self-diagnostics. See ENTERING SELF-DIAGNOSTICS  .
    • Display trouble codes stored in memory. See DISPLAYING TROUBLE CODES  .
    • Select BCM or ECM system (as desired) for testing. See SYSTEM SELECTION  .
    • Select SNAPSHOT test type. See TEST TYPE SELECTION  .
      NOTE: To cancel snapshot test type selection and activate a repeat of the specific test type selection process, touch the LEVL key on the CRT monitor control panel.
  2. Immediately following the selection of SNAPSHOT?, the system will display the message SNAP DONE. This message appears for 3 seconds to indicate all ECM data and inputs have been stored in memory. Following this 3 second information storage verification, the display will automatically proceed to the first available snapshot test type (i.e., SNAP DATA? or SNAP INPUTS?).
  3. At this point, touching the NO key on the CRT monitor panel will display the next available snapshot test type. Display may be toggled between SNAP DATA? and SNAP INPUTS?.
  4. Touching the YES key with SNAP DATA? or SNAP INPUTS? displayed will select that particular test type. From this point, the display is controlled as it would be for non-snapshot data and inputs displays; however, all values and status information represents memorized vehicle conditions. See EXPLANATION OF SPECIFIC TEST SELECTION  and MAKING SPECIFIC TEST SELECTION  .
  5. Touching the YES key on the CRT monitor panel with ECM SNAPSHOT? displayed will display the SNAPSHOT TAKEN message to indicate that new information has been stored in memory.