Front Window Motor & Regulator
WARNING:
To prevent personal injury, before removing regulator and motor assembly, lock sector gear to back plate. Drill a 1/8" hole through sector gear and back plate, no closer than 1/2" from edge of sector gear. Install a metal screw (3/4" long) to lock gear, then remove motor. See Fig 1
.
- Raise window and tape in position. Mark panel and remove inner panel cam screws and cam. Disconnect wiring, punch out rivet center pins and drill out rivets.
- Slide regulator backward and forward to disengage rollers through notch in channel cam. Remove regulator through large access hole. To install, reverse removal procedure. Use "U" bolts and nuts to secure regulator.