LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2017 >> Quest SL >> Repair and Diagnosis >> Maintenance >> Procedures >> Maintenance >> Periodic Maintenance >> Engine Maintenance >> Engine Coolant >> Flushing

Engine Coolant: Flushing

  1. Install reservoir tank if removed and radiator drain plug.
    CAUTION:

    Be sure to clean drain plug and install with new O-ring.

    Tightening torque : Refer to EXPLODED VIEW WITH TORQUE SPECIFICATIONS .

    If water drain plugs on cylinder block are removed, close and tighten them. Refer to  DISASSEMBLY AND ASSEMBLY  . 

  2. Remove air duct assembly and air cleaner cases (upper and lower) assembly. Refer to EXPLODED VIEW WITH TORQUE SPECIFICATIONS .
  3. Remove air bleeder plug.
  4. Fill with cooling water until it overflows from the bleeder plug.
  5. Install air bleeder plug.
  6. Fill radiator and reservoir tank with water and reinstall radiator cap.
    CAUTION:

    Never allow the water to electronic equipments. (alternator etc.)

    • When water overflows disconnected heater hose, connect heater hose, and continue filling the water. 
  7. Install air duct assembly and air cleaner cases (upper and lower) assembly. Refer to EXPLODED VIEW WITH TORQUE SPECIFICATIONS .
  8. Run the engine and warm it up to normal operating temperature.
  9. Rev the engine two or three times under no-load.
  10. Stop the engine and wait until it cools down.
  11. Drain water from the system. Refer to DRAINING .
  12. Repeat steps 1 through 11 until clear water begins to drain from radiator.