Outer Socket And Inner Socket
- Ball joint swinging torque
- Hook the Tool at the measuring point and pull the Tool. Make sure that the Tool reads within the specified range when ball stud starts to move. Replace outer socket (1) or inner socket (2) if measured values are outside the specified range.
Measuring point of outer socket (1) : Cotter pin hole of stud (A) Measuring point of inner socket (2) : Point (B) as shown in the figure above. Tool number : - (J-44372) Swinging torque : Refer to POWER STEERING GEAR .
- Hook the Tool at the measuring point and pull the Tool. Make sure that the Tool reads within the specified range when ball stud starts to move. Replace outer socket (1) or inner socket (2) if measured values are outside the specified range.
- Ball joint rotating torque
- Make sure that the reading is within the specified range using suitable tool (A). Replace outer socket if the reading is outside the specified range.
Rotating torque : Refer to POWER STEERING GEAR .
- Make sure that the reading is within the specified range using suitable tool (A). Replace outer socket if the reading is outside the specified range.
- Ball joint axial end play
- Apply an axial load of 490 N (50.0 kg, 110.2 lb) to ball stud. Measure the amount of ball stud movement, and then make sure that the value is within the specified range. Replace outer socket (1) or inner socket (2) if the measured value is outside the specified range.
Axial end play : Refer to POWER STEERING GEAR .
- Apply an axial load of 490 N (50.0 kg, 110.2 lb) to ball stud. Measure the amount of ball stud movement, and then make sure that the value is within the specified range. Replace outer socket (1) or inner socket (2) if the measured value is outside the specified range.