LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2015 >> Versa SL >> Repair and Diagnosis >> Body & Frame >> Seats >> Unit Disassembly And Assembly >> Front Seat >> Driver Side >> Disassembly And Assembly - Side Air Bag Module >> Disassembly

Disassembly And Assembly - Side Air Bag Module: Disassembly

WARNING:

Do not leave any objects (screwdrivers, tools, etc.) on the seat during seatback repair. It can lead to personal injury if the side air bag should accidentally deploy.

CAUTION:
  • Before servicing the side air bag module, turn ignition switch OFF, disconnect both battery terminals and wait at least three minutes.
  • Handle the side air bag module carefully. During disassembly, always hold the side air bag module, do not let it hang by the wire harness.
  • Always work from the side or back of the seatback assembly, do not work in front of seat.
  • Do not use air tools or electric tools for servicing the seat assembly.
  • Replace the side air bag module if it has been dropped or sustained an impact.
  • Do not insert any objects into the side air bag module.
  • Do not attempt to disassemble the side air bag module.
  • Do not expose the side air bag module to temperatures exceeding 93°C (200°F).
  • Do not expose the side air bag module to any oil, grease, detergent or water.
  • During disassembly, do not damage the seatback board, chutes, connectors, retainers, clips, module harness or the side air bag module.
NOTE:
  • If the vehicle has been involved in a collision and the side air bag module has deployed, the front seatback assembly must be replaced.
  • For side air bag module removal and installation, seatback trim and seatback pad must be removed.
  1. Remove the front seat assembly. Refer to REMOVAL AND INSTALLATION .
  2. Release the lower seatback trim retainer strap (A) from the seat cushion frame.
    Fig 1: Locating Lower Seatback Trim Retainer Strap
    G08203936Courtesy of NISSAN NORTH AMERICA, INC.
  3. Remove the armrest (1) (if equipped).
    Fig 2: Removing Armrest Bolt And Armrest
    G09015323Courtesy of NISSAN NORTH AMERICA, INC.
    1. Unzip the armrest to access the armrest bolt (A).
    2. Remove the armrest bolt (A) and the armrest (1).
  4. Release the J-hook retainer (C), unzip seatback zipper (A) and release J-clips (B) holding the seatback trim to the seat frame assembly.
    Fig 3: Identifying J-Hook Retainer, Unzip Seatback Zipper And Release J-Clips
    G09015324Courtesy of NISSAN NORTH AMERICA, INC.
  5. Reach up through seatback trim and release locks as shown below and remove the headrest holders (if equipped).
    Fig 4: Removing Headrest Holder
    G04146145Courtesy of NISSAN NORTH AMERICA, INC.
    CAUTION:

    Before removing/installing the headrest holder, check its orientation (front/rear and right/left)

  6. Remove and discard the two chute rod nuts (B), then route the chute rod (1) through the opening and remove it from the chute (A).
    Fig 5: Removing Chute Rod
    G09015326Courtesy of NISSAN NORTH AMERICA, INC.
    CAUTION:

    Do not reuse the chute rod nuts.

  7. Release the side air bag module harness from seat frame assembly.
    Fig 6: Locating Side Air Bag Module Harness Clips
    G08203943Courtesy of NISSAN NORTH AMERICA, INC.
    NOTE:

    Take note of harness routing and attachment location for accurate installation.

    1. From the back of the seat unclip the side air bag module harness clips (ARROWF ).
    2. From the bottom of the seat unclip the side air bag module harness clips (ARROWF ).
      Fig 7: Locating Side Air Bag Module Harness Clips
      G08203940Courtesy of NISSAN NORTH AMERICA, INC.
  8. Remove and discard the two side air bag module nuts (A).
    Fig 8: Removing Side Air Bag Module Nuts
    G09015329Courtesy of NISSAN NORTH AMERICA, INC.
    CAUTION:

    Do not reuse the side air bag module nuts.

  9. Release the side air bag module studs from the seatback frame and lift the seatback trim and seatback pad as an assembly from the seat frame assembly.
  10. Pull the side air bag module (1) out of the chute (A) and remove from the seatback trim.
    Fig 9: Locating Side Air Bag Module And Chute
    G09015330Courtesy of NISSAN NORTH AMERICA, INC.
    CAUTION:
    • Replace the side air bag module if it has been dropped or sustained an impact.
      Fig 10: Precaution For Handling Air Bag Module
      G05224522Courtesy of NISSAN NORTH AMERICA, INC.
    • Do not strike the side air bag module.