LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2015 >> Rogue Select FWD >> Repair and Diagnosis >> Steering >> Power Steering >> Steering System >> Removal And Installation >> Steering Column >> Removal And Installation >> Installation

Removal And Installation: Installation

Note the following, and install in the reverse order of removal.

CAUTION:
  • Never impact on the axis when removing steering column assembly.
  • Place a matching mark on both intermediate shaft and steering column assembly before removing intermediate shaft.
  • Never repeat static steering. (Motor and EPS control unit could be heated.)
  • Be careful when removing steering column assembly from the vehicle because it is heavy.
  • Keep steering column assembly away from magnetic sources.
  • Never disassemble steering column assembly. It is not separable.

Be careful of the following points when installing the steering column assembly.

CAUTION:
  • Never reuse cam nut and fixing bolt.
  • Installation of cam nut holder is unneeded.
  1. Check that all parts of the cam nut holder are removed.
  2. Fit yoke to pinion shaft, ensuring no clearance between yoke and pinion shaft.
  3. Insert cam nut fully.
  4. Whilst holding cam nut in position by hand, insert bolt and tighten to specified torque. Take care to hold cam nut in correct axial position during this process.
  5. After intermediate shaft fitted, make sure there is no gap (A) between the yoke (1), pinion shaft (2) and cam nut (3).
    Fig 1: Identifying Gap Between Yoke, Pinion Shaft And Cam Nut
    G05370737Courtesy of NISSAN NORTH AMERICA, INC.
CAUTION:
  • When tightening mounting bolt, never hold cam nut with a tool.
  • Adjust neutral position of steering angle sensor. Refer to DESCRIPTION .