LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2015 >> Rogue Select FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Transfer Case) >> Unit Disassembly And Assembly >> Drive Pinion >> Adjustment >> Total Preload

Total Preload

WARNING: This page is about a different variant/trim than selected.
  1. Measure drive pinion bearing preload (P1 ). Refer to "DRIVE PINION BEARING PRELOAD" above.
    CAUTION:

    Check that the drive pinion bearing preload is within the standard.

  2. Assemble the ring gear shaft assembly to the transfer case.
  3. Install adapter case. Refer to ASSEMBLY .
  4. Rotate the companion flange at least 20 times to check for smooth operation of the bearing.
  5. Measure the total preload with a preload gauge (A) [SST: ST3127S000 (-)].
    Fig 1: Measuring Total Preload With Preload Gauge
    G05370203Courtesy of NISSAN NORTH AMERICA, INC.
    Standard
    Total preload
      All oil seals are installed : Refer to PRELOAD TORQUE .
      Without adapter case oil seal : Refer to PRELOAD TORQUE .
    CAUTION:
    • Each rotational part should rotate smoothly with the specified gear oil.
    • Disassemble the transfer assembly to check and adjust each part if outside the standard. Measure it with the adapter case oil seals removed when measuring total preload after disassembly. Then install adapter case oil seals.