LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2013 >> Sentra SL >> Repair and Diagnosis >> Engine Mechanical >> Engine Lubrication System >> Precaution >> Precautions >> Precaution for Liquid Gasket >> Liquid Gasket Application Procedure

Liquid Gasket Application Procedure

  1. Remove old liquid gasket stuck to the liquid gasket application surface and the mating surface, using scraper.
    • Remove liquid gasket completely from the groove of the liquid gasket application surface, bolts, and bolt holes.
  2. Thoroughly clean the mating surfaces and remove any moisture, grease and foreign materials.
    Fig 1: Removing Any Moisture, Grease And Foreign Materials Using Scraper Tool
    G08989074Courtesy of NISSAN NORTH AMERICA, INC.
  3. Attach liquid gasket tube to Tool.

    Tool number: WS39930000 (-) 

    Use Genuine RTV Silicone Sealant or equivalent. Refer to  "RECOMMENDED CHEMICAL PRODUCTS AND SEALANTS ".

  4. Apply liquid gasket without breaks to the specified location with the specified dimensions.
    • If there is a groove for the liquid gasket application, apply liquid gasket to the groove.
      Fig 2: Applying Sealant Without Breaks To Specified Location
      G08989075Courtesy of NISSAN NORTH AMERICA, INC.
    • As for the bolt holes, normally apply liquid gasket inside the holes. Occasionally, it should be applied outside the holes. Make sure to read the text of service information.
    • Within five minutes of liquid gasket application, install the mating component.
    • If liquid gasket protrudes, wipe it off immediately.
    • Do not retighten nuts or bolts after the installation.
    • After 30 minutes or more have passed from the installation, fill engine oil and engine coolant.
    Fig 3: Locating Bolt Holes And Grooves
    G08989076Courtesy of NISSAN NORTH AMERICA, INC.
    CAUTION: If there are more specific instructions in the procedures contained in this article concerning liquid gasket application, observe them.