LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2012 >> Sentra SE-R >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System - DTCS P0603 To P2A03 (Qr25DE) >> DTC P2100, P2103: Throttle Control Motor Relay >> Diagnosis Procedure

Diagnosis Procedure

  1. CHECK THROTTLE CONTROL MOTOR RELAY POWER SUPPLY CIRCUIT-I
    1. Turn ignition switch OFF.
    2. Check voltage between ECM terminal 15 and ground with CONSULT or tester.

    Voltage: Battery voltage 

    Fig 1: Checking Throttle Control Motor Relay Power Supply Circuit-I
    G04925553Courtesy of NISSAN NORTH AMERICA, INC.

    OK or NG 

    OK: GO TO  5.

    NG: GO TO 2.

  2. CHECK THROTTLE CONTROL MOTOR RELAY POWER SUPPLY CIRCUIT-II
    1. Disconnect ECM harness connector.
    2. Disconnect IPDM E/R harness connector E46.
    3. Check continuity between ECM terminal 15 and IPDM E/R terminal 46. Refer to Wiring Diagram .

      Continuity should exist  .

    4. Also check harness for short to ground and short to power.

    OK or NG 

    OK: GO TO  4.

    NG: GO TO 3.

  3. DETECT MALFUNCTIONING PART

    Check the following.

    • Harness connectors E3, F2
    • Harness for open or short between ECM and IPDM E/R

    Repair open circuit or short to ground or short to power in harness or connectors.

  4. CHECK FUSE
    1. Disconnect 15 A fuse. For the fuse number, refer to "WIRING DIAGRAM ". For the fuse arrangement, refer to , "IPDM E/R TERMINAL ARRANGEMENT ".
    2. Check 15 A fuse for blown.

    OK or NG 

    OK: GO TO  8.

    NG: Replace 15 A fuse.

  5. CHECK THROTTLE CONTROL MOTOR RELAY INPUT SIGNAL CIRCUIT-I

    Check voltage between ECM terminal 2 and ground under the following conditions with CONSULT or tester.

    Ignition switch Voltage
    OFF Approximately 0 V
    ON Battery voltage (11 - 14 V)
    Fig 2: Checking Throttle Control Motor Relay Input Signal Circuit-I
    G04925554Courtesy of NISSAN NORTH AMERICA, INC.

    OK or NG 

    OK: GO TO  8.

    NG: GO TO 6.

  6. CHECK THROTTLE CONTROL MOTOR RELAY INPUT SIGNAL CIRCUIT-II
    1. Turn ignition switch OFF.
    2. Disconnect ECM harness connector.
    3. Disconnect IPDM E/R harness connector E43.
    4. Check continuity between ECM terminal 2 and IPDM E/R terminal 8. Refer to Wiring Diagram .

      Continuity should exist  .

    5. Also check harness for short to ground and short to power.

    OK or NG 

    OK: GO TO  8.

    NG: GO TO 7.

  7. DETECT MALFUNCTIONING PART

    Check the following.

    • Harness connectors E17, F10
    • Harness for open or short between ECM and IPDM E/R

    Repair open circuit or short to ground or short to power in harness or connectors.

  8. CHECK INTERMITTENT INCIDENT

    Refer to TROUBLE DIAGNOSIS FOR INTERMITTENT INCIDENT .

    OK or NG 

    OK: Replace IPDM E/R. Refer to IPDM E/R (INTELLIGENT POWER DISTRIBUTION MODULE ENGINE ROOM) .

    NG: Repair or replace harness or connectors.