LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2012 >> Sentra SE-R >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System - DTCS P0603 To P2A03 (Qr25DE) >> DTC P0850: PNP Switch >> Diagnosis Procedure >> CVT Models

CVT Models

  1. CHECK TRANSMISSION RANGE SWITCH POWER SUPPLY CIRCUIT
    1. Turn ignition switch OFF.
    2. Disconnect transmission range switch harness connector.
    3. Turn ignition switch ON.
    4. Check voltage between transmission range switch terminal 7 and ground with CONSULT or tester.

    Voltage: Battery voltage 

    Fig 1: Checking Transmission Range Switch Power Supply Circuit
    G04925507Courtesy of NISSAN NORTH AMERICA, INC.

    OK or NG 

    OK: GO TO  3.

    NG: GO TO 2.

  2. DETECT MALFUNCTIONING PART

    Check the following.

    • Harness connectors E3, F2
    • 10 A fuse
    • Harness for open or short between transmission range switch and fuse

    Repair open circuit or short to ground or short to power in harness or connectors.

  3. CHECK PNP INPUT SIGNAL CIRCUIT FOR OPEN AND SHORT
    1. Turn ignition switch OFF.
    2. Disconnect ECM harness connector.
    3. Check harness continuity between transmission range switch terminal 6 and ECM terminal 102. Refer to Wiring Diagram .

      Continuity should exist  .

    4. Also check harness for short to ground and short to power.

    OK or NG 

    OK: GO TO  5.

    NG: GO TO 4.

  4. DETECT MALFUNCTIONING PART

    Check the following.

    • Harness connectors F2, E3
    • Harness for open or short between transmission range switch and ECM

    Repair open circuit or short to ground or short to power in harness or connectors.

  5. CHECK TRANSMISSION RANGE SWITCH

    Refer to P0705 TRANSMISSION RANGE SWITCH A .

    OK or NG 

    OK: GO TO 6.

    NG: Replace transmission range switch. Refer to , "TRANSMISSION RANGE SWITCH ".

  6. CHECK INTERMITTENT INCIDENT

    Refer to TROUBLE DIAGNOSIS FOR INTERMITTENT INCIDENT .

    INSPECTION END