DTC Confirmation Procedure
- PRECONDITIONING
- Turn power switch OFF and wait at least 20 seconds.
- Make sure that 12V battery voltage is 11 V or more.
GO TO 2.
- PERFORM DTC CONFIRMATION PROCEDURE-I
With CONSULT
- Check that the charging status indicator is not illuminating, and wait at least 20 seconds.
- Connect EVSE (with AC power input) and wait at least 60 seconds.
- Disconnect EVSE and wait at lease 30 seconds.
- Turn power switch ON.
- Check DTC.
Is DTC detected?
YES: Proceed to "DIAGNOSIS PROCEDURE ".
NO-1 (with quick charge port) >> GO TO 3.
NO-2 (without quick charge port) >> INSPECTION END
- PERFORM DTC CONFIRMATION PROCEDURE-II
With CONSULT
- Turn power switch OFF.
- Check that the charging status indicator is not illuminating, and wait at least 20 seconds.
- Connect quick charge connector.
- Start quick charging and wait at least 60 seconds.
- Stop quick charge and wait at lease 30 seconds.
- Turn power switch ON.
- Check DTC.
Is DTC detected?
YES: Proceed to "DIAGNOSIS PROCEDURE ".
NO: INSPECTION END