LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2012 >> Leaf SL >> Repair and Diagnosis >> Hybrid/Electric Powertrain >> Battery Management Systems >> Vehicle Charging System >> System Description >> Diagnosis System (On-Board Charger) >> CONSULT Function >> Data Monitor Mode

Data Monitor Mode

Monitored Item

MONITOR ITEM Unit Description
Q/CHG CONNECT DETECT CNCT/DISCNCT Displays the connection status of the quick charge connector.
  • CNCT: The quick charge connector is connected.
  • DISCNCT: The quick charge connector is not connected.
Q/CHG START/STOP SIG 1 OPEN/HIGH Displays the input status of the charge start/stop signal 1 from the quick charger.
  • OPEN: The quick charger start switch is OFF and not under quick charge.
  • HIGH: The quick charger start switch ON or under quick charge.
Q/CHG START/STOP SIG 2 OPEN/LOW Displays the input status of the charge start/stop signal 2 from the quick charger.
  • OPEN: Isolation check with a quick charger is NG or not completed.
  • LOW: Isolation check with a quick charger completed normally.
QUICK CHARGE PERMIT LOW/HIGH Displays the transmission status of the charge start permission signal being sent to the quick charger.
  • LOW: Allow quick charge start
  • HIGH: Quick charge start is not allowed
N/CHG RELAY + On/Off Displays the normal charge relay (+) control status.
  • On: Normal charge relay (+) is ON.
  • Off: Normal charge relay (+) is OFF.
N/CHG RELAY - On/Off Displays the control status of the normal charge relay (-).
  • On: Normal charge relay (-) is ON.
  • Off: Normal charge relay (-) is OFF.
Q/CHG RELAY + On/Off Displays the control status of the quick charge relay (+).
  • On: Quick charge relay (+) is ON.
  • Off: Quick charge relay (+) is OFF.
Q/CHG RELAY - On/Off Displays the control status of the quick charge relay (-).
  • On: Quick charge relay (-) is ON.
  • Off: Quick charge relay (-) is OFF.
EVSE SIGNAL PULSE WIDTH μs Displays the pulse width of the PWM signal being sent from the EVSE.
PWM SIGNAL OK/NONE Displays the reception status of the PWM signal being sent from the EVSE.
  • OK: Communicating normally.
  • NONE: Not communicating
AC INPUT VOLTAGE V Displays AC input power voltage.
N/CHG CONNECT STATUS NONE/CNCT/INPUT Displays the engagement detection status of the normal charge connector.
  • NONE: The charge connector is not engaged or there is no PWM communication from the EVSE.
  • CNCT: There is no AC input in the charge connector connected status.
  • INPUT: There is AC input in the charge connector connected status.
QUICK CHARGE VOLT SENSOR V Displays the signal voltage of the quick charge voltage sensor.
ON BOARD CHARGER TEMP degC Displays the on-board charger internal temperature.
VCM ACTIVAT REQ LOW/HIGH Displays the send status of the EV system activation request signal to the VCM.
  • HIGH: EV system start is being requested.
  • LOW: EV system start is not being requested.
Q/CHG PORT TEMP OK/NG Displays the quick charge port temperature status.
  • OK: Normal
  • NG: Temperature is high
PWM SIGNAL VOLTAGE V Displays the voltage of a PWM signal transmitted from EVSE.
CHG CONNECT DETECT V V Displays the signal voltage of the engagement detection circuit of the normal charge connector.