LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2012 >> Leaf SL >> Repair and Diagnosis >> Electrical >> Body Electrical >> Power Control System (Power Distribution System) >> DTC/Circuit Diagnosis >> Power Switch >> Diagnosis Procedure

Diagnosis Procedure

  1. CHECK POWER SWITCH (PUSH SWITCH) OUTPUT SIGNAL 1
    1. Turn power switch OFF.
    2. Disconnect power switch connector and IPDM E/R connector.
    3. Check voltage between power switch harness connector and ground.
      (+) (-) Voltage (V) (Approx.)
      Power switch
      Connector Terminal
      M25 8 Ground 9 - 16

      Is the inspection result normal? 

      YES: GO TO  3.

      NO: GO TO 2.

  2. CHECK POWER SWITCH (PUSH SWITCH) CIRCUIT 1
    1. Disconnect BCM connector.
    2. Check continuity between BCM harness connector and power switch harness connector.
      BCM Power switch Continuity
      Connector Terminal Connector Terminal
      M70 76 M25 8 Existed
    3. Check continuity between BCM harness connector and ground.
      BCM Ground Continuity
      Connector Terminal
      M70 76 Not existed

      Is the inspection result normal? 

      YES: Replace BCM. Refer to "REMOVAL AND INSTALLATION ".

      NO: Repair or replace harness.

  3. CHECK POWER SWITCH (PUSH SWITCH) OUTPUT SIGNAL 2

    Check voltage between IPDM E/R harness connector and ground.

    (+) (-) Voltage (V) (Approx.)
    IPDM E/R
    Connector Terminal
    E17 66 Ground 9 - 16

    Is the inspection result normal? 

    YES: GO TO  5.

    NO: GO TO 4.

  4. CHECK POWER SWITCH (PUSH SWITCH) CIRCUIT 2
    1. Disconnect BCM connector.
    2. Check continuity between IPDM E/R harness connector and power switch harness connector.
      IPDM E/R Power switch Continuity
      Connector Terminal Connector Terminal
      E17 66 M25 8 Existed
    3. Check continuity between IPDM E/R harness connector and ground.
      IPDM E/R Ground Continuity
      Connector Terminal
      E17 66 Not existed

      Is the inspection result normal? 

      YES: Replace IPDM E/R.

      NO: Repair or replace harness.

  5. CHECK POWER SWITCH (PUSH SWITCH) GROUND CIRCUIT

    Check continuity between power switch harness connector and ground.

    Power switch Ground Continuity
    Connector Terminal
    M25 4 Existed

    Is the inspection result normal? 

    YES: GO TO 6.

    NO: Repair or replace harness.

  6. CHECK POWER SWITCH (PUSH SWITCH)

    Refer to "COMPONENT INSPECTION ".

    Is the inspection result normal? 

    YES: GO TO 7.

    NO: Replace power switch.

  7. CHECK INTERMITTENT INCIDENT

    Refer to "INTERMITTENT INCIDENT ".

    INSPECTION END