| B2604 |
PNP/CLUTCH SW |
The following states are detected for 5 seconds while power switch is ON.
- P/N position signal is sent from electric shift control module but shift position signal input (CAN) from VCM is other than P and N
- P/N position signal is not sent from electric shift control module but shift position signal input (CAN) from VCM is P or N
|
- Harness or connectors (CAN communication line is open or shorted.)
- Harness or connectors (Electric shift control module circuit is open or shorted.)
- Electric shift control module
- VCM
- BCM
|