LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2012 >> Frontier SL, RWD >> Repair and Diagnosis >> Suspension >> Wheel Alignment >> Front Suspension >> Periodic Maintenance >> On-Vehicle Service >> Front Wheel Alignment >> Toe-In

Front Wheel Alignment: Toe-In

WARNING:
  • Always perform the following procedure on a flat surface.
  • Make sure that no person is in front of the vehicle before pushing it.
  1. Bounce the front of vehicle up and down to stabilize the vehicle height (posture).
  2. Push the vehicle straight ahead about 5 m (16 ft).
  3. Put a mark on base line of the tread (rear side) of both front tires at the same height as hub center as shown below. These marks are measuring points.
    Fig 1: Identifying Base Line
    G04902059Courtesy of NISSAN NORTH AMERICA, INC.
  4. Measure the distance (A) on the rear side of the front tires as shown below.
  5. Push the vehicle slowly ahead to rotate the wheels 180° degrees (1/2 a turn).
    CAUTION: If the wheels have rotated more than 180° degrees (1/2 turn), start this procedure again from the beginning. Never push the vehicle backward.
  6. Measure the distance (B) on the front side of the front tires at the same marks as shown below. Total toe-in is calculated as (A - B).

    Total toe-in:  Refer to "Wheel Alignment (Unladen*1)*6 ".

    Fig 2: Identifying Total Toe-In
    G04902060Courtesy of NISSAN NORTH AMERICA, INC.
  7. Adjust the toe-in by varying the length of the steering outer tie-rods.
    1. Loosen the outer tie-rod lock nuts.
    2. Adjust the toe-in by screwing the outer tie-rods in or out.

      Standard length (L):  Refer to "TIE-ROD ".

    3. Tighten the outer tie-rod lock nuts to specification.

    Lock nut:  Refer to "DISASSEMBLY AND ASSEMBLY ".

    Fig 3: Identifying Tie-Rod Standard Length & Lock Nut
    G04899148Courtesy of NISSAN NORTH AMERICA, INC.